VEVORElectric Hoist with Remote Control, 440 lbs Material Handling Tool, 110V Electric Hoist with 14ft Remote Control for Factories, Warehouses, Construction Site, Attic

Nice product, Seems well built no issues as of now, easy to install, Fast delivery and Packaged well

works great. if needing a rail to slide the hoist on, be sure to get the correct clamps to install the rail correctly and easily. This hoist works fantastic and is quick and quiet.

The hoist works great. I use it to lift firewood to the second deck of my mountain cabin. Very good value product and works as advertised.

Installed as a hoist for my Jeep hard top in the attic. Working perfectly, not very noisy.

This electric lift seems to be of good quality. It is a pretty heavy unit and most likely you will need two people to put it up unless you get creative. Mine was missing the short lifting strap in the box but everything else was in order. I’ve not really used it yet except for the initial set up. Remember that the weight it shows that it will pick up is when you double the cable. Otherwise it is just half that weight.

Remote works great and is very quick. Noise is about whats to be expected. Good value for the money and after using I would purchase unit again.

I bought one of these winches a few years ago. Works well so far, I use it to store my 5th wheel hitch up in the overhead of my shop. It only gets used when removing or reinstalling my 5th wheel. It is a little noisy but that is to be expected on a winch in this price range. So I bought a second winch to put on a rail in my shop. Surprisingly enough it is somewhat quieter than the first one and seems to function OK for what little I have used it. My problem is with the poor final assembly of the winch.Photo 1 - One of the welded on nuts used to install the hanger brackets on the winch was welded in at an angle.Photo 2 - The spring, washers and safety stop disc (Red Arrows) were assembled on the wrong side of the swedge. In this configuration the traveling block cannot be used. I removed the swedge, positioned the parts on the cable where they should have been and place a clamp where the swedge was and put on the traveling block.Photo 3 - The washer was the wrong size to keep it from being dragged into the traveling block. Fortunately I noticed the problem before it was under load or it would have damaged the spring and other parts. (Red Arrows)Photo 4 - I cut the end off the cable, removed the lower washer and replaced it with a fender washer (3/16" X 1 1/4") so the hoist stop would not bind with the traveling block and allow it to operate as intended. Then I put 1/8" cable clamps were the swedges had been.Evidently they don't do much for final inspection on these winches before shipping them. These were problems that should not have happened and if they did, they should have caught them prior to shipment. If I had used it like it was delivered the safety stop would not have worked as intended and likely damaged the winch or winch parts.

Bought for my husband. He said that it is good quality and works very well.