PERFORMANCE HEALTH Walking Stick Holder for Wheelchair – Cane Holder & Carrier – Mobility Aid for Elderly, Disabled & Handicapped – Secure Clip & Cup System – Lightweight Plastic

This item is of good quality and well made. It is only designed to fit 4 wheel rolators with a 25mm tubular frame, where it fits easily to the long straight sections of the frame.This item will not fit 3 wheel rolators as they usually have smaller 22mm tube size. Because the 3 wheel rolators have more complicated frame designs they do not have long lengths of straight tube to attach to. If you packed out the clamps to clamp onto 22mm tube they would still need to have a pivot to accommodate the complex angles of the frame.To overcome this problem I constructed a frame which gives a length of 25mm tube (plastic conduit) for the stick holder to clamp onto . To connect to the 22mm tube frame I used 22mm plastic plumbing clips intended for copper pipe. These clips where then attached to 25mm conduit saddles, to hold the conduit, with a countersink headed screw and nut with a large washer to form a swivel joint. This arrangement allows the mountings to compensate for the rolator frames multiple angles. Once the frame is fitted and clamped in the correct position it is worthwhile locking the conduit by fitting self tapping screws through the conduit saddles and into the conduit.The main difficulty of this build was constructing the swivel joint. To fit a m5 nut into the 22mm pipe clamp some material has to be removed, overdoing this wrecks the clamp! The other point is the length of the screw, if this is to long it will damage the metal rolator tube when you tighten the swivel up.This mod works very well and the rolators user is very happy. The mod is illustrated in the attached photos.

Easy to fit and holds walking stick

So nice to be able to store sticks on scooter

Plastic seems to be adequate quality.It works. Nothing fancy. Might find the top part is a little large for some sticks but it can be adjusted by running it under very hot water and squeezing it narrower.Wont fit every walking frame obviously but can ofc be 'modified' to fit almost any use case.

Sturdy product, but needed thin rubber mat to fix the bottom piece to the slightly smaller diameter tubing of the wife’s wheelchair . The same applied to the top piece as well. Also the top piece needed to be opened out a bit with the aid of a Stanley knife to accept a slightly bigger diameter crutch, but it works well.

Bought to attach to a rollator but it doesn't fit and the holes are too small for holding a folding walking stick with a ferrule attached. In fact I don't know what size stick it would hold. Totally useless piece of equipment for my needs.

Used for clipping a walking stick to a rollator. The stick has a large foot, so the stick foot holder was no use, and I used two sets of the upper holder. The mounting brackets are designed for larger-diameter tubing than the rollator I had, but that was easily fixed by padding with neoprene strips, cut from https://www.amazon.co.uk/gp/product/B09PBLMJ4G/.

Great for having the stick at the front of the wheel chair just where you need it when getting in and out , no messing about screwing clips round the stick just a click and your ready to go , excellent!