Red Label Abrasives 2 X 72 Inch Non Woven Surface Conditioning Sanding Belts for Knife Makers and Metal Fabricators - Coarse, Medium, and Fine Grits Sand Paper - 3 Pack Assortment

These work, simple as. Fit my 1 x30 no issues except the grey one (most coarse) was a little tight to the frame of the machine, the machines issue not the belt. Very impressed with the results if you move up through the belts, really nice finish can be achieved ina short space of time. Will buy again

These are a must if you want to make knives at a high level of quality and also be efficient. I don’t have tons of time to hand sand blades since I’m not a full time bladesmith. These give you the same or better finish plus it’s done in a fraction of the time. The amount of time spent doing a satin finish on 2 blades was less than half the time I’d spend hand sanding just one side of a blade. They are pricey, but if you use them correctly these can last a long time and save hours that could be spent on production or personal/family time. Word of advice - don’t start using these until after you’ve ground off forge scale or at least a rough belt finish on low grit. It will prep the blade for using the conditioning belts so you’re not wasting the abrasive.

Muy buena calidad, Made in USA, lo compré para limpiar herramientas antiguas, en USA llaman a estas bandas de acondicionamiento son como las fibras scotch brite pero más gruesas, trae fino, medio y grueso

Exactly what I needed for De-burring

Super cool thing to have for the knife maker or metal worker. Leaves a unique uniform finish without deep scratches. Good value because they’re very durable and will last and last. Takes the hard work out of hand sanding.