eMylo DC 12V 2CH RF Relay Wireless Remote Control light Switch 433Mhz Receiver with A/B Button Transmitter

I bought a 6 channel with 2 remotes, my board had 2 bad relays on it I removed and replaced them myself. I'm sure the seller would have made it right with me but it was not eligible for prime and it took the slow boat over if you know what I mean. So I had a couple of larger relays, and I soldered some leads with spade terminals into the board to plug the new relays into. That said I am in a wheelchair, and I am using the remote, and relays to operate my van doors, and the solenoid valves on my hydraulic lift. It is working quite well for me. It has only been in operation for one day. I will update later and if the reciever holds up driving the larger relays I may up my rating.

Batteries not included for the remote which is okay, but you'll almost definitely strip the screws that hold the remote together trying to get them out to install the battery. Screws might as well be made of wax. Very unlikely I'll get a second battery change before they're completely destroyed.

so far it has worked perfectly and I didn't even pull out the antenna on the transmitter. I wired it just like it shows and it was a great edition to my halloween trunk or treat contraptions!

Excellent product. Allows for bistable operation. Good range on the remote.

Although in concept the unit would function fine and is exactly what I needed. IT IS A COMPLETE FAILURE IN PRACTICE. This because of the terminal lugs used. You can barely put one 16 -18 gauge wire in. And to supply power for what every you connecting this to, you really need to daisy chain the power side of each relay. As running 8 separate input wires would be redundant and not practical with the tiny size of the whole in the plastic cover for the input/output wires. To test this i use 22 gauge wire and where there were two wires they barely fit. That folks say this can handle 20A 120V is ridiculous because of connections noted above but also the physical size of the relays, How could they have contact points large enough to handle anything beyond a trivial amount of current? And no real space between them to dissipate heat.I would not us this for anything more than a hobby board as I would be afraid of a complete electrical failure and fire from overheating... See pics for wire size i demo'd Indeed the lugs as so small you have to use a Xcelite R3322 screwdriver. A "little red" R183 is too big and will not fit.

Worked great

Upon receipt it was noiticeably dusty and the relays were bent.I gave it a short test to find out it is working as advertised.Though upon installation, it was challenging finding a screwdriver small enough to fit the terminal strips.During operation I also noticed that the relays were getting quite warm.As a conclusion, it gets the job done, but forget about heavy duty applications

Very easy to install, good instructions, now all boat lights on this fob, + garden lights on another.

No trae instrucciones.¿Cómo se configuran los modos de operación?: Hay que pedirle instrucciones al vendedor pero las envía rápido.El tamaño de los bornes es muy pequeño, 1mm2 como máximo.Poco espacio para los cables: La caja debería ser algo mayor.En modo momentáneo sólo funciona un canal al mismo tiempo.El alcance rf es correcto.Para el precio que tiene está bien.

ho usato questi telecomandini per uno spettacolo teatrale. tutto ineccepibile, arrivato entro i termini previsti

buono