DIY Tool Kit Coil Jig Winding Set,Ceramics Tweezers,Coil Set,Wire Cutter,Folding Scissors, Coil Brush, Screwdrivers with A Carrying Case

The small wire brush you can use to clean your coils is really useful. All the little tools are well made. Handy to carry with you if you want to change the cotton on the fly.

I bought 2 vape coil kits, this one and one without a case, and it fits both inside, with a bit of tetris-ing, as you will see in the photo, all good quality except for the ceramic tweezers which snapped so I had to buy some more, again as you will see in the photo, and it all fits quite snugly now.

Decent set everything you need to start making coils. Dropped a star as the jig wasn't the straightest (still works fine) and the tweezers had a slight bend at the point (still fluff the cotton fine though!). The bag is decent the scissors are sharp & the ceramic tweezers are worth it for strumming and firing. The t-bar is useful as are the screw drivers & the snips are solid and sharp enough to trim your coils. After reading reviews I decided on this as opposed to the one with the v2 coil master, as my mods give accurate ohm readings and are solid enough to work with.

Very good

Well it lasted a little while until the snips broke while cutting a coil with normal pressure everything else in the kit are good

Everything is very useful in this kit the scissors are a bit on the blunt side but if you have a knife sharpener at home then you can sharpen it up and it’s good to go over all this is a good starter kit for any new vape users

Was downsizing because I only use mesh now so don’t need all the tools I only wanted the case so gave all the bits to a friend who vapes and has a lot less kit than meHad to be this because the textured outer layer is what I clean my mesh on with a wire coil brushI have altered it.. I bought some elastic ribbon and I customised it to my needs... well I’ve done 1 side the other 1 I’m procrastinating on but eventuallyReally happy the size was exactly what I expectedWith my alterations I can store...wire brushCotton tweezersCotton scissors3 boxes of nexmesh for the profile 1.5My WOTOFO profile mesh curling barMy screwdriver and both heads needed (flat head for all the skrews and the Allen key for the squonk pin)4 batteriesAnd 5g of cottonAlthough with all that it is rammed full 😊Epic little vape kit if u want it to be.. and a pretty handy well priced kit as stock

Does the job, get what you’re given, no need for expensive coil kit as this will do perfectly, comes with all you could need to install and wick your coils🤙🏼