HICTOP Ender 3 Heater Cartridge 24V 40W 1M/39.4Inch for Creality Ender 3 Ender 3 Pro Ender 5 CR-10S Pro 3D Printer Prusa Mendel （Pack of 3）

Works just as stated.

Rapido y seguro, segun como indica la descripcion.

Bought these to repalce a burned out OEM heater cartridge on an Ender 3 V2. I picked these specifically because it has a longer cable at 1.5m. It was more than enough length to reach my mainboard from the hotend and follow a little bit longer path. It heats well as OEM and fits in the block the same way. Happy with the purchase.

The wire is about a foot too short to go from the board to the hot end on an Ender 3v2. I had to solder a length of wire to fill thengap

The cable was just the right length for my ender 3, the pre stripped wires were a huge convenience, and it works great so far.

Product received in new condition, consistent with product description ordered

been fghting with thermal runaway issues replaced other parts and reset some settings, but nothing worked until i installed this

3 stars because the product works, however the wires are significantly shorter at about 100cm than the stock heater cartridge at about 146cm wire length. I'll probably only have use of about 75% of my z space until I find a longer one to replace this one.

I have used these on my Wanhao Duplicator i3 plus and they seem to be better quality than the original part! The silicone insulation on the wires is much better quality than the stock part. Great price!

Good

These are great. The cartridge that came with the printer failed after only 20 prints. This one has lasted over 100

Worked as expected, heats up quickly.

Works great