12 Pack 3M Sticky Adhesive Replacement Compatible with Socket Mount Base VHB Sticker Pads for Collapsible Grip & Stand

I picked these up because I got a new phone case and my normal popsocket just wouldn't stick to it. After using these adhesive pads I haven't had an issue and the pop socket it stays where it's supposed to be. Very happy with them.

Very good product, way better adhesive than they put on popsockets. Thank you

I got a new phone and clear, acrylic back case by Spigen. This tape was great for re-using my Popsocket. It is EXACTLY the same the same size as the Popsocket back. You need to line the edge with the outer edge of the Popsocket base so that the edges are flush with each other. The pop socket base looks like it has a lip, but ignore it. Line it up edge to edge, and it will fit. Color in my pack was clear.Here's how I put it on: peel off the yellow backing paper, put the dot sticky-side up on a table, lower the Popsocket onto the dot, with edges flush with each other, rub the dot onto the Popsocket, peel off the red backing, stick the Popsocket onto the case.

So far so good. Stuck to the base of my popsocket and has a strong grip on the new phone case.RECOMMEND for sure.

These things are strong!! Great for my dash cam holding power!!!

I always keep these on hand because I use the popsocket on my phone all the time. The ones I've had before were clear and these were black. These said 3M, and what could be better than that?When I needed to replace a clear one that had been on my phone for months, I popped it on and within a couple of hours it started stretching and fell off. So I replaced it. The next one lasted less than a day. Then I got out the directions read them and followed them. I used a pad to clean and then one to dry, and held the new sticky pad in place for 20 minutes. Then for 24 hours I did not extend the popsocket except twice when I forgot and immediately closed it again. That was two days ago, I believe, and today it came off again. I'm searching out the clear ones again.

I pulled off my favorite pop socket from my old case and used this to affix to my new iPhone. Yay me.

I was surprised by how thick they are and there was like extra product on the edges. I had to cut it to fit my pop socket holder. But the hold appears to be good.