GLOBACT 550 Brushed Motor 12T and 80A ESC Brushed Motor ESC Combo ESC Dual Mode BEC 5A 7.4V/6.4V for 1/10 RC Truck Car Slash 2WD 4×4 Arrma Granite Senton Typhon 4×4 Redcat Axial HPI(XT60 Plug)

Recommend for all rc car / truck x10 more speed x10 way more power 👍👍👍👍👍👍👍👍👍

Installed in a basher/trail build. Great value, used a program card I had lying around and it worked like a charm, was one of the cheap ones. Don't listen to the other reviews that say this ESC doesn't work, obviously someone that didn't have a clue about RC's wrote that. There are jumpers to make it go into high speed mode, or to put in crawler mode so you have a drag brake (just like the description says). Also has jumpers to choose what you want your BEC to be set at. If the motor spins the wrong way, reverse it on your transmitter... Pretty simple stuff, not a ESC problem. Don't let someone's bad review make you pass on this, I'm super happy with it. Actually bought another one of the motors for another project and that is also going strong. The ESC can run 2s or 3s, it's a rebranded surpass hobby 80a. If running a 12t motor however, the motor is only rated for 2s so just keep that in mind. Overall I would say it's very similar to a hobbywing 1060. Has great slow speed for crawling or trailing and also punch for bashing. Hope this helps! Have a good day.

I got this one for my dad's slash 2WD after getting one for my slash 2WD runs smooth with plenty of power for a brushed motor. After 6 months the ESC is starting to brake down getting hot and causing the truck to stop and lock up after full acceleration and will not allow the truck to turn without sliding the truck around.

I got 2 new ones and they both don’t work anymore after a few mints they just only go one way and that’s it. I’ve had only no problems with the first two that I bought, but the first two new ones that I did buy they didn’t last at all. They only lasted like not even a few minutes more or less a few seconds after I went outside and tried to run it.

Originally purchased this for a rock crawler build but ended up putting just the motor in one of my Tamiya tt02 touring cars and it handles 3s bashing very nicely. I have not used the esc as I am using the esc from the Tamiya kitI think this is a great value for the cost

Up graded the ESC and motor for my 1/12 desert car works well

Upon first use I found that there is no low voltage cutoff on this ESC or it's way below what it should be. Once I noticed my car slowing down I decided to test the battery voltage and saw that it was down to 6.9V (which is way lower than safe minimum for a 2S lipo) and the ESC was still operating normally. This ESC will ruin your lipo batteries, do not buy it!

Very nice and seems like it’s good quality.