DiabloSteel Demon Cermet II Saw Blade for Metal - 6-1/2" x 48-Teeth, Triple Chip Grind - D0648CFA

This blade is solid and cuts Efficiently. I have used it for baking down old bed frames and other metal furniture parts for disposal. If that is your task then this blade will save you a ton of time at a very reasonable cost.

The Blade works great. The only problem is the seller will only send you one blade and not two like the description says.

I just got these in a few hours ago. They are for my Makita cordless, so power is limited. These are very thin. I needed to cut some 4 inch steel channel. It is holding up a raised deck on a trailer. I need good clean edges.I cannot use a band saw for obvious reasons. A 7.5 inch angle grinder cutting disk would not get me where I need to cut, nor cut cleanly. A plasma torch would also not provide that accurate and clean edges I need.My first cut was in stages of 1/4 inch per cut. No problem. My second cut was all the way thru except for 1/4 inch on the inside leaving little legs that I will cut later after putting a support under the deck to lift it some.I am really amazed at these blades. I wish I had gotten some long ago.Update of earlier today [ 9-23-24 ]I got the blade in a bind and broke off one of the carbide teeth. I was fortunate it was not several. The metal I was cutting got in a bind due to how it was made.I used that same blade to cut thru 5 more pieces of 4 inch wide channel steel. The blade worked so well I could not tell it was missing a tooth.Good job Diablo!

I bought it for a project of building a shed out of isolating panels. The frame was made from 1.2mm profiles, and the blade cut them with ease. The same goes for the panels, but the metal "skin" in those is just 0.5mm. It made clean, straight cuts with ease - much faster than a jigsaw with a metal blade, and nicer looking cut.It also cut softwood very nicely, leaving a crisp edge, with practically not tear outs. Great for cutting lumber that might have nails or staples in it.

This blade is the cat’s meow, it cuts rebar and steel plate like butter without a bunch of sparks leaving minimal burrs , it cuts aluminum extrusion , brake metal and bar stock without clogging & makes nice clean cuts in wood and plastic too. The thin kerf allows more cuts per charge. Wear your safety glasses!

Only one blade arrived!Very strange packaging too.Good price for 2 but horrible price for 1.Very disappointed

I use Diablo as my go-to blade for all of my general wood cutting tools and for my recip saw blades. I recently picked up a Metabo metal cutting cordless circular saw and figured I would try the Diablo metal blade. So far, I'm mainly using this in mild steels and this blade works great. Don't push and just let the blade do the work and it will last a good while.

They arrived with scratches all over them. Like they weren't packaged well or something. The one I used seemed to cut well, but I like my new products to look new when they arrive.