II Decal Application Fluid for Glass and Cold Weather Intermediate and Specialty Films (32 oz.)

Good for surface prep and installation of vinyl graphics on cars.

This stuff really is helpful when laying down rap you can use it as a cleaner and then as a Adhesive Promoter as well

Easy to find and easy to use. Good price

I was helping my brother install some vinyl badge and wheel overlays on his Ram and saw a video using this product. Well, it got me thinking about some Lux tail light tints I had bought about 3 months ago. I really struggled with those because they would stretch and warp a bit as I tried to install them and then they’d be nearly impossible to align right. So I had quit on that project but decided to try again with this in my arsenal. Ordered another set and using the slippery fluid made the alignment much easier and gave me time to properly align the pieces without any stretching out. Was very happy with the results. A little goes a long way so I should have bought the smaller container and saved a few bucks but all in all I’m happy with the product.

It works.

First off, the product works. I used the RapidTac Prep first, then RapidTac II. Yes, it does allow one to position graphics then set them. However, it does not let you slide them around, you have to lift and re-position. It only is a problem with very large graphics. I have used this on race car graphics that were large and I "managed." In the future I will most likely use Slide-On from Phoenix or Classic.

I use this for any stubborn stickies on the car. bird turd, tree sap, and goo....this works.

I used this to clean the surface of my Honda Passport door sills. Then applied generously to the surface and the back of the decals. I was done less than 3 minutes later. Following directions in how to move the fluid with a squeegee and I could not believe how fast what little air bubbles there were took to remove. Worth every penny. This is a professionals solution to applying vinyl decals.