Abatron WoodEpox Kit - 2 Gallon - 2-Part Structural Epoxy Adhesive and Wood Hardener - Wood Filler Putty

Good product although expensive. Works easily, stays where you put it, does not droop, smooths with wet hand or tools, hardens solid, have not tried to sand yet.

Surprised this product is not more widely available. Its easy to work with and better to for larger areas that need filling or even reconstructed. Indoor and Outdoor. Sandable, Paintable. It does what plastic wood and similar cant. Its not the mess wood bondo is either. This product is more working with playdough instead of some thick glue or lubricant.

This product worked better on vertical surfaces than the bondo or powdered wood products I've used in the past. Had some porch posts to repair as well as a couple of railings and this product in conjunction with the liquid wood hardener works quite well. For the tops of the horizontal railings that had some shallow rot I used the epoxy putty mixed with some of the hardener and it was easier to spread and push into the wood surface. The product is expensive but if you're working on irreplaceable trim I think it's work the cost. I was surprised at how easy this sanded too. Hopefully the repairs will last indefinitely.

works well. easy to mix. working time long enough to get the job done. USE VINYL GLOVES. tends to get "sticky" as it is used. lightly moistening gloves (spit) helps. had damage on a header board behind fascia board. much easier to build up the rotted areas than to cut out and replace the header. rot depth about 3/4 inch on nastiest place. prep the board. remove rot, seal with liquid epoxy.

We have a staircase that connects the ground to an elevated deck, and although the deck is covered most of the staircase is not, which in the rainy South means rot is going to occur eventually. This product filled in gaps caused by removing rot and saved time, materials, and money by extending the life of the wood. This is super easy to use. Remove all the rotted bits with a chisel and a brush, then apply a hardener then this will push into the void filling it completely, then after it dries sand it then finish with paint and you’re good as new.

The epoxy jars are both dry, I didn't expect that. Mixing was a bit tough but worked great. Made a very solid bend on very old cracked wood! Filled large areas and sanded great! Painted looked great.

I applied this product to the bottom of a solid door which had some rotten wood which I had removed and put this product in the gap where the bad wood was removed. While it did harden it remains chalky and unusable for me to put screws into it to hold the door's lower metal insulation plate. I gave it weeks to harden and then finally ordered a similar product from Amazon called P.C.Woody. I just did a test batch with it and it is hardening way better than this product and it will be able to handle screws and not crumble like this product does. Now I am faced with having to throw away this inferior product and start over again replacing it with the P.C.Woody product. Unfortunately I waited too long to return it. I am out some forty plus dollars and will never recommend this product to anyone.

Works well. seems stronger than the wood. i used it to repair a spindally stool leg; part of a wooden stool with a tapestried top I made in jr hi decades ago. i put a pencil-sized dowel in the center of the leg years ago after my sister tipped it on one leg while standing on it. That worked for years with a glue, but this seems stronger. I didn't know how much i would need and made quite a bit extra. it has a fluffy, spongey texture when mixed. My daughter made the leftover putty into a model of a shark. cute.

Quando vivevo negli Stati Uniti, usavo sempre woodepox. Sono così felice di poter comprare in Italia!

This product is significantly superior and cheaper than anything available in Australia. Application is easier, especially when replacing missing wood. It sets solid. It sands super smooth. It's paintable after priming No wonder I can't find it here on shelves.

In two boxes is a paste which I’ve melted in my hands wearing first gloves. It’s ready in two minutes but to shape it was better after another 10 minutes. The filler was very good for me because doesn’t dry in seconds so I’ve had a time to put it everywhere where I needed and even I could move from one place where I used it too much to another hole where I didn’t have enough of filler. So far I’m happy with the product but we can see in a year 😁

Perfetto

Just try. You will see 😉