TRUGLO Tru-Bead Universal 3 Dot Turkey Gun Sight Sets, Fit Guns with Ventilated Rib Fiber Optic, Rear Ghost Ring and Notched Rear Sight, Standard Threaded Front Sight/Dual Color Threaded Front Sight

The Truglo Tru-Bead Turkey Sight w/Ghost Universal - Dual Color sight package value cannot be beat in my opinion. Many places you're going to spend just as much, if not more, just for the front sight alone. And here, you receive the front sight with dual colors as shown, traditional rear rifle sight and ghost ring rear sight (both with green fiber optics for easy sight alignment in almost any lighting conditions. The fiber optics really glow well in the outdoor lighting.The only real downside to this package is that the instructions are not all that clear, nor do they distinguish which four (4) front sight screws are for which possible make/model. Really though, figuring out which screw you need for the front sight hole is the toughest part about this.Though in the instructions it does not advise whether or not to use Loctite I would advise using it. Small screws backing out at the wrong time sucks.And yes, from now on, any shotgun I purchase that has the ribbed barrel I will be putting these sights on it immediately.

Fit on one 870, but another 870 had a press-in front bead. Also fit on a Winchester 1300 20ga. Frickin nice set up for turkey.

As a note, I have note tried shooting my shotgun yet post installation, this is only about the initial installation. In the picture with all the components, I hadn't tried screwing anything in yet and the small screws and larger screws should be flip-flopped.I have a TC Encore shotgun and these sights installed easily with this shotgun with one exception, the front sight screws that came in the package are not compatible. The screws to install the front sight are very short and only meant to screw the sight directly onto the vent rib. I had previously lost my front bead and had a replacement rib vent screw that was just a hair too long when just securing the vent rib to the barrel, however, it worked perfectly to install the front sight. So I used a screw I already had to install the front sight, not one from the package. This is the only reason why I gave it a four-star rating.The four screws (all of different thread sizes) are meant to screw the front sight directly to the vent rib and not go through the rib vent into the barrel.There are four front sight plates which you choose one that is compatible with the vent rib width. For my TC Encore I used the second largest size. I don't know what the widths of each are though. The plate that sits on the rib vent has a lip on each site that should face down onto the vent rib. This is what prevents it from sliding sideways on the rib vent. This plate has a small hole that aligns with a matching nub on the underside of the front sight.For the rear sight, the instructions don't give you any suggestions on how far back to put the rib vent, I put it as far back as possible. The longer screws in the package are to secure the lower plate and upper plate of the sight to the vent rib. I found it worked much easier to install when you slightly threaded the screws on one side and then slipped it on to the rib vent and then screwing in the other screws.The Tru-glo sticks are initially installed on the rear sight, but I took that off and put the peep sight on. It slides onto the sight mount and then screws into a nut underneath using the smaller Allen wrench provided. The small-exposed screw you see between the sight and plates of the plate mount is what you use to change the elevation. You loosen the screw that holds the peep sight in place for windage.I would highly encourage using blue loctite or similar threadlock when putting this on to prevent the screws from unscrewing when you go out to shoot.

The ghost ring is too small and is loose no matter how much you tighten the screw. Don’t buy if that’s what attracts you. Overall, it is ok and is a quick inexpensive fix for turkey season.

I don’t know why this sight has bad reviews . It has plenty of adjustment for different guns . It fit perfect on my glenfiel 778 12 gauge and works great.

Complete waste of money. The front sight fell out after the first shot.

This is one bad ass sight. Installed on my Mossberg and it fit perfectly. Would recommend to hunters or people who shoot for fun.

Flimsy front sight, the rear sight is solid.

Top Visierung. Selbst bei geringem Licht strahlt die Visierung als ob LEDs verbaut wären.Wurde mit wenig Aufwand auf meinem Nachsucherepetierer verbaut.Klare Kaufempfehlung.

Fits and works as described and works well in low-light conditions. Long term, a hard-kicking shotgun will shake things loose and and I've used Loctite and glue to fix that problem.