ANYCUBIC TriGorilla Integrated Main Board Compatible Mega2560 & RAMPS1.4 Combo Control Board 4 Layers PCB Controller Board for RepRap Mendel Prusa I3

The Anycubic Service department instructed us to purchase this board as a replacement in the Anycubic Chiron when the fan stopped running that was cooling the heatsink (above the hot end) causing the filament to heat up before the hotend and clog the bowden tube. A component right beside the fan connector on the original board was burned out.We had to download the firmware for the Anycubic Chiron from the Anycubic site. Then install a driver (provided by Anycubic) on the computer that we were using to upload the firmware to the board. Then we had to installed Cura version 15.04.6 to use for uploading the firmware to the board. It is important to use this older version of Cura (downloaded from the Anycubic website), since newer versions don't allow you to manually set the serial port to communicate with the board and don't seem to be able to automatically recognize the board. We started a new print, and so far it seems to be working. The Anycubic Service department was a big help in getting us back up and running.

I fried my motherboard, and the replacement from the manufacturer was sold out. I was SO glad to find this on amazon. Worked perfectly, and now my machine is up and going again.

I got my I3 Mega in January of 2019. In early May of 2019 the original board that came with the machine blew a component. I was sent this one as a replacement under warranty. It lasted until November of 2020, then it too blew a component.Now my machine is unusable unless I buy this again or upgrade to a higher quality.Use at your own risk.

a good board if you plan on uploading newer firmware this is and older bord but will still take Marlin 1.1.9 and work well

perfect replacement for my Anycubic Kossel Linear Plus.

It was used to replace my forward that got damaged and worked as soon as they put the new board in

My printer was broken and I was told get a new motherboard would fix it, it most definitely did not fix it, the hotend fan won't spin no matter what.

Like others said, you must be prepared to flash the board but Cura makes it really easy with youtube guidance. Surprisingly cheaper then AliExpress by $10.