DEALGADGETSUnder Cabinet Lighting Plug in, Hand Wave Sensor Under Counter Lights Indoor, 6000K Cold White, 3pcs Dimmable Wired LED Closet Lights for Kitchen, Cabinet, Cupboard, Workbench, Desk

Everything about these lights are top Drawer!So happy I found them!You won't go wrong with these!

This daisy-chain of DEALGADGETS undercounter lights just fell down one star in every way possible.First and for me, foremost— They have no K or Kelvin, in other words, "color" selection. The manufacturer says they are 6000 K, but it seems higher to me. That's great if you want these only for Work lights, but is useless if you need good, but unobtrusive softer lighting.The motion detection seems to work reliably, but my hand has to be far too precise in locating the detector. I suppose if you get used to "waving" exactly where the sensor is under your cabinet, over time it would feel less frustrating while trying to do other things and find the light sensor at the same time.The mounting clips for the lights are not well thought out. They stamped a protrusion into the flat clip to keep the screw head from running into the actual light strip, but then didn't insure that the thickness of the double-stick foam tape was thick enough to overcome the protrusion. In addition, the bottom of most kitchen cabinets are not solid wood. They're MDF or worse, particle board, and getting anything to stick to those materials is always difficult. The screws have to be short to not punch through , so you need both the screws and the foam tape to keep them in place, but the foam tape is too thin to work. (See My Annotated Picture below)Here's The Summary— These are single-color, bright white strip lights with no "softer" color ability. There is only one of the "light strips" that has the on/off sensor on it, and you have to be Very Close to it with your hand to trigger the switch. In almost all cases, mounting the "clips" that hold the light strips in place will be more difficult than it has to be, due to a mounting method that is not well thought out.

Easy to install and work great

I bought these again and again adding more and more lights to my liquor cabinet.I daisy chained as many as 9 in a row and they work great!|Now i have lots of left-over USB-C power supplies. * DANGER * DANGER * DANGER * DANGER *DO NOT USE THIS USB-C CHARGER TO CHARGE YOUR USB-C DEVICES!!!!I blew out 2 headlamps, 1 set of bluetooth earbuds, and a personal project made from an ESP32 project board before I figured out the charger is overpowered. I caught on when smoke came out of the ESP32. (Apparently. I am kind of slow.)But thank God for the Google Engineers!!!I plugged my Pixel7-Pro into this charger - and the phone did NOT blow up.There is WARNING text printed on each chargerbut it just says keep it dry - and assures you it is standards-compliant.It does not warn you that it will fry your gear!!!

I'm rating 3 stars which means they work ok, but there were some caveats during installation:- the adhesive mounting option is basically worthless; the adhesive pads sit below the screw hole on the mounts, so they BARELY make contact with the mounting surface, if at all, unless you bend them a little or press super hard. One of the three sets stuck for me, the others were flat-out not thick enough to touch anything. Or you might be able to use some other type of adhesive or dual sided tape, if you don't want to physically screw them in to something.- the description shows that it comes with two small usb-c-to-usb-c connectors for installing the lights flush with each other. My set did NOT come with these connectors, only the short cables. Which is fine but then I had extra cable maintenance to deal with, and I had to waste a few inches of space in between the bars.- for some reason, for about half a day when I first installed these, the 3rd light bar would stay constantly on and would not dim or power off with the other two bars. I rearranged order and cables but to no avail. Then after several hours, it just magically decided to pay attention and no problems since then. Weird behavior, though..But other than that, once I got them mounted finally, they seem to work fine. The light dims and brightens as expected, and no issues with the sensor so far. Also something to keep in mind is that they are motion activated, but this does NOT mean they are motion detecting; you have to wave your hand within a few inches of the sensor in order to turn them on/off.Also when they are off, the primary bar emits a very dim, green indicator light, so it's never 100% dark.

Muy buena calidad recomendables

Have had daily issues with our 2 sets periodically going into flashing modes and having to repeatedly toggling them off/ons to settle them down......Do not recommend these lights...

I zipped these lights under my kitchen cabinets in about 5 minutes. The double sided tape on the brackets stuck fine and the lights just snap on. If your installing near the stove, the cabinet surface may be too greasy to use the adhesive, but that's where the included screws come in handy.I also like the included wire clips to keep things tidy. All told for this 3-light system, this is a good value for the price!