Lifegard Aquatics 3/4-Inch Slip Bulkhead Fitting

Worked perfectly

Great product

Works well for my application

On my 80 gallon reef tank

Okay, I'm using two of these "not as intended."After my home was nicely resided, I wanted a clean look to getting the 220v cable from the A/C disconnect box into my house. Nothingexists currently, except drill a hole, pull the cable through it, slap on a bunch of silicone.Instead I used a Carlton PVC type L junction box with a 3/4" stub into and out of it. With a small amount of sandingthese slip bulkhead nuts fit on the stubs and are easily cemented in place using PVC grey cement.Then one goes into the metal disconnect box, and you tighten it down (washer provides watertight seal).The other one goes into the hole through my new Hardie siding. The nut secures it inside (drywall isn't up yet), and again thewasher provides a seal.Someone should market this.It looks professional and I'm sure will last longer than me.

Was not comparable with 3/4th PVC, unfortunately.

I used these to build a canister filter out of a 5-gallon bucket and they work 100% better than uniseals. I'll stick with these bulkhead fittings from now on. The holes I drilled in the plastic buckets were a little wobbly so I added some silicone sealant before tightening, and there are no leaks. 3/4" slip bulkhead fittings worked with 3/4" PVC pipe just fine.

Worked fine, once I purchased another one that was a bit smaller. I forgot to account for the outside diameter being another 3/8" wider than the OD of the PVC pipe. Both items where adequate in there construction and materials.