HiQltyla 3 Way Speaker Crossover, 200W Passive for HiFi Home Audio, 2 Pack

These are dirt cheap and just as good as anything you’re going to find online from specialty speaker supply retailers that use overseas sourced components under other brand names. They work and sound great, and if you want to modify them with higher quality name brand parts, you can do so very easily. These revived an old pair of Yamaha floor speakers I got for free at a garage sale.

I’m using a car audio amplifier for some Dayton audio speakers and the crossover on the amplifier wasn’t giving enough of a full sound for me, (setting high and low pass to 90hz as recommended). These sound fantastic and make the speakers blend fantastically. I do not recommend using a subwoofer with the bass output on this crossover use the 90hz lpf instead because it does not block out the middle-low midrange on the bass output. Instead I recommend using a larger PA midbass-midrange style woofer such as a 8 inch like mine or even a 10 in a 4way set up like mine. A 6.5 would work but I’m not sure it would have as much of the lower midbass range as you larger woofers. Also it says 4-8 ohm but I have one crossover on a bridged channel to my mids and tweets to a final impedance of 2 ohms ( 4-8ohm svc speakers, +and- all wired together on each drivers), so you’ll be safe as long as you don’t drastically exceed the 200 watt rms rating. I’m going to make another speaker as shown in my picture and use it in a dj set up it gets loud and very crispy clear. I can’t record and play Bluetooth at the same time otherwise I’d record a video but I highly reccomend them for a similar to mine setup. The subwoofer is a 10 inch infinity kappa car subwoofer in a 1.5 cube 32 hz tuned birch 4 inch circle ground firing-ported box that works great in home audio or car audio applications as well.

Works good at stabilizing ohms. Worth the money but not so good at separating bass, tweets, and mids. Not best sound. Would recommend for lower end systems.

I am impressed with this crossover! I have bought higher end crossovers that sound worse. Along with some new woofers, these brought new life to some old yamaha 3-way speakers. The audio is clean and flat enough for me personally. No shrill peaking or ultra bright highs.

Well built with good quality components, small enough to use in small cases, very happy with my purchase

I bought this item to repair Fisher ST-9418F vintage speakers. The resistors and capacitors were old and not working properly. I found the replacement parts but they didn't make the leads on the resistors long enough to for me to solder them in. I decided to try these crossovers that matched the specs for my speakers. I should have done this from the start. I replaced the crossovers in both speakers in about 30 minutes. I saved myself hours of soldering and removing old capacitors and resistors. I can definitely hear the quality of the sound before and after. Everything is more crisp/clear. I would definitely buy this item again.

these crossovers made my speakers sound really tinny and squeaky took them out and will modify them to different specs.

They give the life back to my old Bose 201.

スピーカー自作、改良される方にお勧めです。 大変満足してます。

Sound quality is good, works very well.

Muy fáciles de instalar y muy buen sonido

Excellent crossover, works as needed. truly starts to shine at around 30watts rms. Clean high frequency with little to no frequency distortion/bleed.

Used it in my Sound Dynamics 300ti. The original mid sounds very very quiet. Overall improvement in the sound after using these crossovers.