3” Shock Bracket – 6mm HRP&O Steel, 1/2" Bolt Hole, Fits 1.75"–3" Tube – Universal Shock Mount for Custom Off-Road & Performance Suspension Systems – 2 Pack.

I got these shock brackets to use for adding shocks to my trailer. It was very bouncy because it's a heavy duty trailer and when it's not loaded it was just all over the place. So I thought if I got some shock brackets I could mount some little shocks like off of a golf cart or something and that would help cushion the bounce. And I was right. I needed more than a golf cart shock though something a little more heavy duty so that it actually had compressive strength under no load. These worked fantastic for being able to put the shock mount wherever I needed it to be to work for my specific application highly recommend these for anybody who's doing a custom shock mount

Nice quality. Great for making kustom shock mounts

I like the product but i need lots of them and i would like to get in touch with the manufacturer to get bulk pricing. 🤠

I added shocks to my little trailer, which I could not have done without these brackets.

made my job to install coil over very easy

I used these on a 150cc go-kart, which I'm sure was not its intended application. Nonetheless, it worked out great. I had to cut it in half and re-weld it to make it narrower to fit my smaller four wheeler shocks. Then weld to the frame. The steel on these brackets is thick, and they are quite heavy duty. No doubt they would work better on a pickup truck.No complaints overall. These worked well, and saved me a bunch of time versus fabricating my own.

They are coated in some kind of zinc plating, I think. Had to grind down where it needed to be welded, not too thrilled with the way they sit, the shock is kinda hard to keep aligned, might be best for the lowest shock mount not the highest. Kinda overpriced, wish it came with upper and lower mount.

I used these to relocate shock mounts after doing an axle flip on my F100, they worked well. I had to bend them a little but that isn't a bad thing, being able to manipulate the part so it fit well before welding in place is why getting parts in this condition is so nice for fabricators.