Monave 10m Drain Rods Flexible for Pressure Washer DCH01 Drain Cleaning Kit Compatible with Karcher Lavor Bosch Pressure Washer, Pressure Washer Accessories

It does the job, it worked OK with my pressure washer, it came with two different size brass fittings to lock the pressure wash line to my triger handle, so I had full control at all times, well worth the money, for me.

Worked very well for cleaning ground drains that were blocked with dead leaves

Seems well made and good value.Sadly I wasn't able to get the tubing to travel as far as it needed to to clear the blockage. I don't know if that was because of want flexible enough or because the drain was only a soakaway.I'll be using it again where I know there is a normal drain, but that won't be for sometime.It's a difficult balancing act between flexibility and strength.The nozzle pushed lots of water backwards, but wasn't as powerful with the forwards jet as expected.

Does its job but is not as described, the fittings state it fits Bosch power washers, the fitting for it does not and required some judicious filling to get to fit the lance, once done performed well

The pipe does leak a bit at the jetwash end as others have said, but in terms of its job, I was able to thread it through a 1.5 inch soakaway entrance and clear a stubborn blockage in seconds. The Karcher adapter fitted without any difficulty. Nice piece of kit!

This worked like a dream. The trick is to hold the lance on whilst feeding the pipe down.It self feeds itelf if water pressure on and you have properly unwound the pipe so it's straight as you can get it. This way the pipe does not kink.Wished I bought the 15m but 10m is fairly long.

To begin with I was a bit disappointed. The pipe is not very stiff, I did not see me pushing it very far into the drain!The stainless jet tip is screwed into one end which has a reinforced sleeve, there are no instructions for this. I used a Karcher K2 compact and fitted the adapter to the other end.The adapter fits well into the Karcher ’gun’, with the unit switched off I pulled the trigger until water came out of the nozzle.The drain is about 2 foot deep in a manhole and is 4” in diameter and just over 10m long.Feeding the pipe in was difficult because it is quite flexible, I was not sure why until I powered up. With the nozzle only just in the drain I pulled the trigger and the nozzle went down the drain!!There are three jets facing backwards that push the pipe along as the main jet in the front clears the way, genius!!Things to remember:-Use the supplied PTFE tape on the adapter end else it will leak.Mark the length of the drain with tape on the pipe, stops you getting carried away!!I am very pleased with this, I have the 15m long pipe and it worked perfectly. All drains free running now!!

did what i needed to achieve easily.