Scope Throw Lever for Primary Arms 1-6x24 Scope Gen 2 and 3 Does NOT FIT Raptor/Platinum

Nicely machined and quality piece. Comes with the allen wrench needed for install. Fits perfectly. Works great for power changes on the fly. Throw arm could probably be a touch shorter since this is mounted to my do all AR and I worry about it getting snagged on stuff. On the flip side of that coin the extra length makes adjustments super easy so I can't nit pick too much. Kind of wish I could index the thing so I could do all manipulations with my left hand without having to tilt the rifle. This is no fault of Aim Assist since Primary Arms puts the nub on their power ring and that nub forces you to a particular install location. This thing is priced the same as the plastic ones the gun sites have and is much better quality so in my opinion this buy is a no brainer. I'll be buying the version they have for the Primary Arms 4-14x44 that I have mounted to my .308 rifle.

Just got it in yesterday and it went on without a hitch and seems to be rock solid. Fits perfectly and looks good. Can’t really ask for more, it makes changing power levels super easy and fast. Finish on the piece itself is very nice as well. If it breaks Or malfunctions in any way I will update my review but at the moment I don’t see that happening seems to be of the best quality. Really my only negative is I just wish it was a little shorter but that’s more of a preference than anything not a con. They make some for other scopes I have and I’ll probably be picking a couple more of them up.

Fits very well, fairly easy to install. You will need a very small hex key to get the small bolt that secures it installed. It's not as wide as the knurls on the scope, so I mounted it approximately in the center such that a small surface of each knurl protruded equally on both sides of the throw lever. Adds no appreciable weight to the scope, but makes turning the magnification ring much easier.

So far so good. Easy to install and comes with correct allen wrench also. The lever is a little long but not that big of a problem. Perfect fit on a primary arms predator 1-6. Sure makes adjusting the zoom easy.

Super easy to install and fit the Gen III Primary Arms 1-6x24mm scope perfectly. I wouldn't mind if the lever was slightly shorter, though. It sticks out quite a bit. I would think I'd still be able to get a good purchase on it, even if it were a few mm shorter. What I'd really love is a folding lever for when I put the rifle in a case. And since we're talking about wish lists, why not have the perfect solution: Primary Arms could make their magnification ring with an ever-so-slightly larger ring. Anyway, Aim Assist did a good job on this product. Fit, finish and quality are all top-notch and I'm looking forward to shooting with it.

It was soooo easy to install, works like a throw lever should, PERFECT FIT and is NOT PLASTIC. I've seen a lot that are polymer or other non metal materials. Every review I've seen of those said they break. This one is durable and metal. I got a little rough with it to test it and it didn't bend or break. This really helps for my coyote hunts when those buggers pop up out of no where. lol

This throw lever is well-manufactured, easy to install, and fits perfectly. It seems expensive, but is actually less than any others I found except for the 3D printed stuff that I just don't believe would last. I'm pleased with the purchase and recommend it to anyone with the Primary Arms 1-6 Gen 3 scope.

I wish it was a little wider, for better comfort when you whack it with the side of your hand in a hurry. But it certainly does the job, fits perfectly, easy to install, etc. I installed and use this on the Primary Arms 1-6x24 FFP model, in case you were worried it only works with the older/cheaper SFP version - the two scopes share the zoom ring.