Rugged Ridge | Switch Pod Kit, A-Pillar, 4 Switches, Black, LHD | 17235.96 | Fits 2011-2018 Jeep Wrangler JK

Installation was bit tricky since the pod wasn't an exact fit. A heat gun and a bit of patience solved the problem. Also, heat the pod slightly to help cut out the blanks with a utility knife. However, looks great and clearly belongs in the Jeep.

OK, to start, yes you have to take your time scoring and cutting out the blanks. That being said, I did rush on one, broke the center spacing, but a little crazy glue and it was right as rain. Once the switches are installed, this is not visible any way. One big positive note, the complaints that this comes with only one clip and that you have to scavenge a clip from the tailgate have been addressed. My pod came with both clips attached. One none product related issue was the removal of the upper trim piece. This has a plastic molly type expanding fastener that was a pain to reinstall, and probably took the most time of the install. The pod did need some adjusting to fit the contours, but the end result looks perfect. I am totally pleased with the results. I did look up some You Tube videos on wiring and copied the layout for running a single positive and ground to power the switches, (I actually spliced two of my positives and grounds together to get a beefier current. I would suggest that you use the red switch for the most used lights as the blue could be a distraction at night. I used the blue for the 50 light bar myself. Give your self some time and cut out the blanks a day or two before the actual install to make things easier.

Buena calidad solo tengan cuidado al retirar las secciones en donde colocarán los switch , es el mismo material que el original

This thing is AWESOME! Put it in my 2015 Jeep Willys Wheeler and the color, texture- everything matched and it looks super clean! Don't settle for eBay switches, this is a quality brand and fits super well. I depend on these customer product reviews a great deal, so I tried to sum it up and show how happy I am with the product. Only difficult part was cutting out the panels for the switches, my only advice is FOLLOW THE DIRECTIONS. It tells you to heat the blade and cut the inside first, then widen as needed. DO THIS! I cut the corners a little too wide on one, luckily you can't really tell but you can up close- completely my fault but still...be cautious and take your time. Overall, great product!!! A++++++

Mine had no gaps. It fit perfectly, and looks amazing. The shapes are hard to cut without screwing up. I used a Dremel and went nice and slow.