Cajun Bowfishing Aluminum Spincast Reel Mount - Simple and Easy-to-Install Design for Fishing Rod Attachment to Be Mounted Into Bow Stabilizer Bushing

I bought this reel seat for a purpose other than fishing, but I still need it to hold a Penn 320GT2 LC reel. If you are mounting a reel larger than this one, you might not get the mounting ears on the reel to fit, but it managed to accommodate the Penn. The machine work and finish are fantastic on this reel seat, and I think it will provide years of service. Oh, for the curious out there: I am using the reel seat and reel to lower and raise a pressure recording device into and out of drill rods to check water levels on relatively deep (>1,000') water exploration drill holes!

It works ok, but the metal used to hold the reel is quite thin,and is easily bent causing the reel to loosen up. Other than that it's not bad

It is a neat little attachment that can save $100s. Insted of buying the whole kit. you just attach this the you can put any reel on.

Attached to an old Jennings in the stock mounting hole and attached the Shakespeare Synergy Ti20 to the post. Seems to hold snug and after several practice shots the reel didn't fall out and seems to hold.

This reel seat definitely does the job. Although it was a bit of a pain to get the reel perfectly straight. It would've been less confusing if it would have came with some directions. I wasn't able to get the reel to sit straight while also tight in the stabilizer threads. I spent about an hour figuring it out. So here, I'll post some directions.1. Thread the mount about halfway into your stabilizer threads until you have the inserts for your reel at the top aligned. You only want it halfway so your reel button doesn't touch your fingers while holding your bow.2. There should be two nuts on the thread. Separate them and loosely tighten one towards the reel. Once again, loosely tighten the second one towards the bow. There should be about a cm gap between the two nuts.3. Take two wrenches or vice grips or one of each, whatever works. And tighten the nuts, in opposite directions, at the same time while keeping your reel mount straight. This will allow you to get a really snug fit.4. Place your reel into the mount. Hand tighten the two threaded rings up to the insert. Make sure your reel is nice and snug. Grab your vice grip and crank the rings in as far as they will go.5. For extra sturdiness I then took my vice grip and bent the front reel insert snug around the reel. The reel still slides out fine with a small amount of force... Much better than having a loose reel moving around.All in all, this is a great low price reel mount. Just make sure you buy a bowfishing pole tip to insert into the front of the mount and you'll be set! Looks absolutely fabulous on my Cajun Sucker Punch. I highly recommend this setup over the AMS Retriever if you're an experienced bowfisher. Its reeling is just much, much faster... And cheaper, can't beat that!Good luck and shoot straight!

Doesn't snug up good on the reel. The sliding part broke on first use. There are better options for the money.

The seat is functional. Seems fairly cheaply built and the threaded end is bent slightly causing it to point slightly off of the centerline of the bushing on my bow, but it does what I need it to do. For what ever reason I thought it included the rod tip. Which it does not. I probably would have bought a different one had I known.

As expected, quick turnaround and good product!