Speaker Wall Ceiling Mount Bracket One Pair for Universal Satellite, fits Keyhole and Thread Hole with 1/4 20 Threads, 4mm and 5mm Black 1ST

These are very well designed and made speaker mounts. I used them to mount my Sony SA RS 3 under my upper kitchen cabinets to compliment my soundbar and subwoofer. Clean concealed design, easy to install and adjust.

These worked very well for hanging speakers from the ceiling as long as you can find the ceiling joints

I used these to mount a pair of Polk Signature Elite ES10 speakers as surround speakers. They are rated for up to 10 lbs, and the speakers each weigh 6 lbs. If you are pushing the 10# limit and using the extended length bracket like I did, you might want to think twice. For my installation, I used these mounts on the wall beside the speakers and used the longer of the two included brackets. There was some sag on the speaker after tightening the bracket, so I had to aim the speaker higher than intended, tighten, and then allow the speaker to "sag" down to the desired angle. Not ideal, but after some trial and error, it worked. If someone were to bump the speaker, I am certain the mount would move/bend/break. I did install the mounts through the wall into wood studs, and the mount to wall is very secure. I had looked for a mount that was more secure, but this seemed to be the best I could find that used the threaded mounting option. I deducted one star due to it "sagging" after tightening, but would purchase again for my use, especially given the reasonable price and lack of substitute.

There used to be a few generic speaker mounts specifically designed for junction box mounting, but they have all been discontinued for a long time and I was unable to find something similar anywhere. Another reviewer of this product modified it and mounted it directly to his junction box and posted photos of his setup. I won't reproduce his steps here, other than to say that instead of using a plastic blank wall plate, I used a metal one, and instead of driving one of the mounting screws into a block of wood, I just used a machine screw and nut combination for the mounting hole that was not being driven into the slots on the junction box (if you do this, make sure your speaker wire jacket is undamaged/properly insulated to prevent a short if they hit the machine screw. That being said, the method described by the other review would have also worked well, I just didn't have any extra lumber handy. Please note that my satellites are only 3 pounds--although this mount technically has a 10 pound weight limit, I would be very hesitant to mount any speakers heavier than 5 pounds using my method if you have plastic junction boxes (if your boxes are metal and properly secured to a stud, you might be able to use the full 10 pound limit). Overall, I'm very pleased with this hacky setup. Even when used in ceiling-mounted junction boxes, the mounts and speakers are sturdy and aren't going anywhere, and they allowed me to mount the speakers in an unobtrusive way that uses the existing junction box to hide the speaker wire.

I'm specifically here to let those who own the Boston Acoustics Micro 110x surround speakers that these work! After 4 years being divorced I finally got my system back including a solid Denon receiver. However the ex lost the surround mounts, the power cord for the subwoofer, the remote you name it! Because my speakers have the mounts on the bottom this mount worked perfectly! Screwed right into the mount terminal, tightens up and very versatile. Got the wires run through the attic and ready to go. Waiting on the power cord for the sub but when it comes I am going to have a good old time! The speakers are 3 lbs and these mounts hold strong! One thing other reviewers have stated is that the ball at the end of the arm does get scratched so wait until you mount it to get it properly positioned but I am sure it will hold up to 5 lbs at least if not the specified 10. The hardware stinks as other stated so I grabbed a good set of drywall anchors at the local box store. I have no doubt these mounts will hold for the future. If you have the same speakers this is the mount! Great price, fast shipping and a perfect fit!

Worked perfectly with my very old Bose satellites. Best thing is that it comes with two different variations so you can test out different angles. Also feel well made, and won't break or slip.

Perfect! Mounted on the ceiling, in corners. Pretty easy installation, and they solidly hold our Polk ES15 surround sound speakers (identical size [and weight, I think] to ES10's in case that helps anyone) pointing exactly the direction we wanted, which is diagonally down toward the center of the room. These were a great value for the price, and adjusting to get the angles "just right" wasn't too tough. Very happy with our purchase and would buy again.

Excellent compatibility; the thumb screw adapts to the size you need. Minus two stars since the screws they supplied were too big for the drywall anchors that they supplied. I tore apart a piece of my ceiling trying to screw the supplied screw into the supplied anchor before realizing that I needed smaller screws. Insignia™ - 2.0 Mini Soundbar

Really good build quality. I've just ordered even more to keep on hand because I was so impressed by how small but sturdy these mounts are. I really like the angled attachment they come with too.

Se adaptaron a las bocinas Onkyo del teatro en casa que tengo y se ven muy bien.

👌

used to mount a pair of polk om3 speakers to the ceiling

Um ótimo produto