ZTUOAUMAZTUOAUMA Ignition Starter Switch 1874535M3 3107556R92 with Cap for Massey Ferguson 230 231 240 250 253 261 263 270 271 281 282 4800 6140 JCB 35670 Lucas David Brown 1190 1194 1210 Case 238 248

Great

Worked fine once installed in my MF 231 (1995). Blades on switch were a bit thinner so had to squeeze connectors with needle nose to tighten them up. Also, the old Lucas switch was not completely round. It had a flat area that is used as a key when inserting the switch through the mounting dash plate. The new switch would not go through without enlarging the dash plate slightly. Luckily the dash plate is thin metal, and using a step down drill bit worked fine to enlarge the hole. Once in the switch worked just fine.

todo excelente

Works but a few frustrating issues.Key does not come with rubber capsPosts are very thin so I had to change the wire connections to hold.Retainer nut would not screw onto ignition, had to use one I had around.

good

Ford Tractor 3000

Worked great

1995 231 massey. Bought this to isolate electrical problem. Turns out my original was good and I had a bad PTO switch. I will keep this one as backup as it works as it should. However the blades are so thin the connections to the switch will not stay attached. I had to use electrical tape to keep them in place. Not sure how long that will last as I suspect they will vibrate off the back of the switch. So will put the 28 year old switch back on and put this on the shelf. Also the picture shows keys with black plastic or rubber thumb break! No mine.....thin key my twist off before long. Emergency use only.