APIELE 3Pcs 2 Position Rocker Toggle Switch ON/Off AC 125V/20A 250V/16A for Boat with LED Light DPST 4 Pins KCD2-201N (Red)

Replaced switch on my meat slicer. Easy install. Recommend.

The switches are very sturdy, have great action, and fit the panel cutout for my UTV like a glove. Was able to quickly repair and get back into operation with these.

I matched the switch to my heat press to this kind of switch and received after a few days (2 days early) it was identical so I was able to disconnect wires from the original to connect here with ease. Switch works perfectly and my heat press is back online. I previously tried changing the fuse but discovered I had a bad switch after 1 year of having my swivel heat press & when changing the fuse didn’t work I decided to change the switch. If changing out the switch had not worked I would have had to purchase a new control box which runs for $60+. In getting (10pk) fuse then switch (3pk) I was able to keep repair cost down and spent under $15 for both those items. If your heat press control box goes out before having to spend a lot of $ for a new one or box try fixing the little things first and you could end up saving $...it just takes a bit longer to get to the issue unless you purchase fuses and switches together vs what i did which was getting them separate

if both Line and Neutral are connected on the "bottom" (the pins near the zero edge) then the little indicator will light up when switch is on (one position).it doesn't matter if the load is connected at all.The only problem is with the color. Even though this green lens you see amber light. Not the prettiest picture. Not a big problem, may even be beneficial - no mistaking it for a reflection.You may want to select the amber or red version it will be a better color match.

I have a heat press machine and the on off switched burned out. This left me dead in the water with making items. The order was shipped extremely fast and the the switch was easy to install. All I had to do was slide off wire and push bad switch out the push new one in and reattach wires. From start to finish less then 5 minutes.

I got these switches in September, it is November and I've had one fail on our coffee maker. The amperage and everything is the same as the old switch, but maybe just a quality control issue? My wife is running a coffee maker and it started to smoke. I've got another one, going to try it too. We'll see if I get 2 months out of it.

It exactly replaced the defective switch in my scroll saw -- and lights up when turned on. I am pleased.

Got these for my FDM, was using way below their supposed rating, one at < 8A, one at ~6A and one at ~ 1A (120V ac). They seemed ok at first, after a dozen cycles the issues started. Two of the three would sit there audibly sizzling inside, either immediately or after a few minutes, flipping them off and on would solve it temporarily, but before long they were back to making me worry about fire, ozone, or shock. One would suddenly cut out after a few minutes of use then reconnect itself after a few seconds. The rockers have noticeable wobble and play in it, I think that as they warm up they flex enough to make intermittent contact, but I didn't bother to tear one down to investigate. Changing them for good switches from digikey and no more problems. Cheap, out of spec, cloned garbage, like pretty much everything else on amazon. Not worth the risk for ease of ordering and free shipping.