Closet Door, Bi-fold, 6-Panel Style Solid Wood (80x24)

I am happy with these doors.Plan on sanding and finishing before installing.Be sure to read the instructions and layout the parts on the floor and determine which of the door guides and pegs goes into which corner first. Two pegs (one top and one bottom on the wall hinge side) make the door pivot hinge. One peg goes into the top guide plastic slider on the opposite side from the pivots.Stand the door up into the opening before doing anything. Measure and work out the exact height of the door in the opening including any bottom door thresholds. I needed to add a 2" x 4" filler across my opening on top (1` 1/2 nominal) and then after notching my bottom threshold piece for the bottom peg bracket 1/8" the door fit perfectly. Spend time to get it right. There is really only a slight chance to adjust the pivots by a small amount vertically. Once installed the first time, I dont think there is much chance of taking the door out to adjust things without damaging the pivots slightly.The top guide is installed with the bent end on the side of the pivots and guide braket. You will see the guide channel rails are bent in on one end to hold the pivot peg tightly. Once again be sure you have it right there is not much room for adjustment after the door is in.Now after installing the top guide you can check the height one more time. There is really no room for adjustment other than the top filler. Make sure you understand where everything goes and how it works before installing the doors in place.After everything has been finished and hardware installed you can install the door. Put the pivot peg side into the top guide bracket first, then the top peg into the guide on the other side. Finally slide the bottom pivot into the bracket. Make sure this bottom peg is screwed all the way into its sleeve when inserting the door. Then you can unscrew it to adjust the height somewhat. Luckily mine fit tight with the bottom peg insert screwed all the way in. I used a chisel slid under the door in the crack and managed to pry up and lifted the door so the peg insert went tightly into the bottom bracket. Finally, I leveled and centered best I could by pounding the bottom peg insert slightly over. Lucky with a proper wack the insert slid over a bit and now the door hung perfectly level, straight and opens smoothly.There is also an adjustment bracket and set screw on the top guide to move the door slightly left and right. Again there is little room for error here. Lucky mine did not need much adjustment.I added a piece of corner round down the door frame on the opening side for a door stop and to cover the 1/2" gap I had left in the width of the door opening. I could not get a filler piece to sit properly on the other side to fill that gap so I just left it.It was a two day project for me myself and I. I have good skills and it was a bit of a challenge as are most things.Overall I am very happy. I gave it 5 stars since although the door hardware is not perfect there is not a 4.5 stars.:)Tom

Love this folding door

Most importantly, the door works great and looks great... but the instructions were not easy to understand.

Solid doors that come with basic hardware. It is better to purchase premium hardware to avoid maintenance in the near future. I put mine on a bi fold barn door system instead, which requires some modification of the typical instructions because these doors are thinner than typical barn doors. Use washers. Drill a new hole for the bottom door hold. Sealed with wipe on poly.

The track has two sharp edges that point inward instead of being completely rounded out. The guide is just a plastic peg, that rubs along these sharp edges every time the door opens and closes. So it doesn’t slide well, makes a nails-on-chalk-board sort of noise, and the guide is quickly being eaten away.The doors don’t fold flat when it’s fully opened, leaving a three inch gap between the doors.

The doors are well made and install easily, but 1 of the 4 doors was warped on the bottom. They provided a hardware bracket that takes care of this. Used the customer service link to let them know that another door that I bought from Amazon was only available as used and was missing some hardware. They responded immediately and FedExed a complete hardware set in 2 days. I’m 100% satisfied!

Product as described, stained beautifully, and easy to install.

Very beautiful doors. They hide my laundry machines and are heavy enough to block a lot of the noise.