Winegard SKA-004 Traveller Roller Pad for LNB Bracket

Easy install on our motorhome. Trailer 1000 was making a small dimple in the fiberglass roof. Used dicor to "glue" it to the roof. Works perfect!

Allows for the roller to land on this rather than your roof

Didn’t use - not required for non rubber roof on RV

Super easy install. It is just the right size to protect my roof from the roller on the dish when being stowed or deployed.

Not what I expected. It is only a couple inches by a couple of inches, and if you order the big plate (ska-008), you don't need this one. However, if you are mounting the dish on the roof of your motor home, I definitely recommend the larger plate to provide support. You only need THIS plate to provide a location for the arm to rest (and rub) as you drive down the road, and only if you haven't provided any support for the Trav'ler on your roof.and the arm will be resting directly on the soft membrane of your roof.

This item is NOT needed if you purchase the Winegard Traveler mounting plate SKA-008. I purchased both just in case the mounting plate didn't extend far enough to be under the rubber wheel on the antenna. I don't think this piece of metal with 4 screws is worth the price.

EXACTLY AS DESCRIBED

I installed this on my trailer roof and it protects the rubber roof very well. Before installation you could see where the roof was wearing some and this will protect the roof much better. Well worth the cost and time to install on your trailer roof.Much cheaper than a new rubber roof.

C'est petit et fait le travail demandé.

To expensive for what it is - a small plate with 4 holes!