MOTOR METER RACING Classic 6 Gauge Set with ECU Based Electrical Speedometer Digital Odometer Black Dial White Needle Light Bulb Illumination 85mm 3-3/8" & 52mm 2-1/16"

The media could not be loaded. I rebuilt all of the gauges in my 1965 Barracuda. All of the sensors that came with the set all work and all the gauges work the way they’re supposed to. I’m very pleased with the outcome of the gauges in the dash they look amazing and it still gives it that classic look that the 60s cars had back then.

Very nice looking gauges

This product is a fine looking set of gauges. In fact they are a fantastic looking set of gauges and they looked absolutely AWSOME in my custom built dash that I built specifically for these gauges. And that's where it all goes down hill. The tac is jumpy with poor response. I see others have mentioned that in their posts too. The Temp gauge quit working in one day. Also you will need to buy an adaptor for your temp sensor if you are installing in a GM product. The adaptor in the kit will not fit GM. Speaking of sensors. Read them carefully. Notice the Ohm range on these sensors are a little uncommon. Meaning use the sensors provided, you stock ones will not work with these gauges. Leading me to the fuel gauge, With an in tank pump this is a bear. They provide you with a cut in top load sending unit "Generic" however this would require you to cut your fuel tank. Folks if you don't know what your doing when cutting a fuel tank just don't do it. That can be extremely dangerous. Anyway I finally custom built a bracket connected to the existing fuel pump assembly. The pick up on the sending unit was not adjusted correctly from the factory. I had to bend the sending unit pick up rod so when the sending unit reached dead top the gauge registered full and when the sending unit hit bottom then it registered as empty. This is on the sending unit itself, I'm not talking about adjusting the float rod. The volt meter worked. The oil pressure sensor provided is very tricky to wire into a system that requires the oil pressure sensor to send a signal to the fuel relay. Once again generic or OEM sensors will not work with these gauges. I am so sorry, I swear I'm not one of these trolls out here bashing stuff, in fact I rarely write a bad review. In this case, It is what it is. I cannot recommend these gauges even to worst enemy.

haven’t installed yet but gauges are a perfect fit to replace the original gauges for my 1956 Ford Fairlane

Bought two sets of these for two different Harley's. Customer support sent video to assist with setup. Gauges look really good!Fuel gauge requires adequate voltage to read properly, sending unit works well.Tachometer works pretty good once you figure out the setting for it. Two cylinders are challenging but I’m sure standard 4/6/8 and two stroke boat motors etc would be perfect.Best way for customer support is contact through Amazon seller.Seller corrected all little issues via email.

FIT

Look and feel like a quality product

Fuel gauge did not properly work even with a fuel bridge.... Water temperature center ridgeway , high and low pressure reached low.... Even bought separate replacement fuel gauge and still did not work right