Arduino Nano With ATmega328

Good performance

Works perfectly. The header pins are soldered which is good but the pins were crookedly bent in all directions so affixing it onto the breadboard was a little tricky.

Works great for all I need, it was easy to setup, also because of the global shortage in atmega328 chips the seller understandably sent an atmega168 chip nano, which works fine for almost all of my use cases, and will work for anyone, since there is almost no functional difference between the 2 for 99% of the use cases. They even sent a note saying so and cautioned me on how to select the correct board version on the Arduino IDE. They even offered a refund if I needed, but it's a great board and I have no issues!

Very bad product doesn't work no detection at arduino software very bad

Very good product. Much smaller form factor than expected which was great! Four stars because this is an Arduino Nano clone which uses an CH340G Serial/USB Chip rather than a FTDI chip. Need to get the driver installed from chip manufacturer to allow communication with Arduino IDE. Just search for the driver for your OS and it adds a serial port through which you can program the Arduino.

I ordered 3 boards, one of the board USB pin was broken and remaining board pins are dry soldered at time of order received.

Now you do not need old bootloader, it works on the new bootloader. very nice and compact. Solder only the holes that you require. Good for permanent projects where the board is soldered for permanent uses. Always mount the board on a piece of thermacole or might get shorted while experimenting. No problems with CH340 so far using CH341 Driver.

This is a Arduino clone and uses cheaper CH340 chip. I face some problem in using chip as CH340 driver have some compatibility issues.