Lifegard Aquatics 1/2-Inch Standard Threaded Bulkhead

Works well!!

The media could not be loaded. Got this to use with the pig water nipples that I got from tractor supply. Installing just the nipple led to leaking, but combining with this has made the barrels leak proof and made my life much easier when it comes to making sure these guys have plenty of fresh clean water.

Great price, easy to install, a stepped drill bit is a good idea. Used these along with pig watering nipples to build a waterer for our pigs and it’s worked great! A lot of people complained about these cracking or not sealing it’s simply not true, the trick is go easy, don’t over tighten them! I went hand tight plus a quarter turn, then filled the barrel and checked for leaks, not one drop. So far they have been in temps down to the low 20s and the water has frozen near solid once. So far not one leak

Very sturdy. Used various types of this product to construct a water filter/source outside of a fountain I made. Drilled a hole in a 5-gallon bucket and place one of these if the fountain reservoir (tub) as a drain hole into the 5-gallon bucket. Unfortunately, I drilled the drain hole too close to a ridge in the tub. Installed one of these and tightened this up and no leak, even with the poor choice of the drain hole location.This is not going to break on you. The threading is smooth and these are tough enough to tighten down without damaging the material.I would buy these again should the need arise.

I recently bought a small Wet/Dry vac that is designed to mount to a wall, for cleaning up melt water from the snow our car brings into the garage . Removing it from the wall, all its tools, and tool rack, etc. to empty the tank when is inconvenient, as it won't hold enough water to do the whole job in one pass. Unlike larger Wetvacs, this one has no drain port. You have to remove the top to dump the tank. So I added this fitting, an adapter to garden hose thread, and a garden hose valve to the side of the Wetvac tank at the bottom. I can easily drain it into a bucket how ever many times are needed, and only have to remove the Wetvac from the wall once at the end of the job, for air drying the inside. The fitting is well made and does not leak.

I used this bulkhead fitting and a nipple waterer for my pigs. Works great - heavy duty and no leaks. I highly recommend this product.

Looks like metal in picture, my bad on not reading material. Used them for pig nipples and they broke one is hours. Next in a day and another in another day so 1 left after 3 days. Do not suggest for any animal that could be rough.

There are usually four combinations to bulkheads, thread/thread, slip/slip, thread/slip, and slip/thread. The description just says threaded bulkhead so I assumed it was a thread/thread, but it is not. It's threaded on the flange end and slip on the other with no threads. I needed threads on both end so this won't work for me. Quality seems a little better than ABS bulkheads, but I'm only rating it a three since the description is incomplete.