2-Pk Universal Golf Car Turn Signal Buzzer Beeper Electromagnetic Buzzer Kit Universal for Club Cart, EZGO, Yamaha

I ordered these little sonalert devices with the hopes that they would work for my Red Hawk LGT-112A golf cart blinker system. The Red Hawk blinker system does not make a sound when activated. Therefore, they can be left on and forgotten. I was able to easily solder these little sonalert devices to the main circuit board inside the blinker handle to make a sound as the blinker is blinking. They are small enough to fit inside the blinker handle. You must solder to the front blinkers only, since the back blinker lights are also used when braking. I used the red and green wires, and they work great! So happy to have a sound when the blinkers are activated. A++++Update: They came with crimp connectors, but I didn't use them since the wires are tiny and work great for soldering. I'll probably just keep the crimp connectors for some other project. I just soldered the little red wires to the same location on the circuit board where the front blinkers wires were soldered and found a common ground to solder the little black wires. The blinker case has enough room on both sides of the wire harness to fit the little sonalert speakers, so they are fully encased in the blinker enclosure. Works great!!!

comes with everything you need. you can find youtube videos on how to use ttap connectors that was helpful. My complaint is that the Buzzers are not loud enough for me. I will be returning for alternative.

I bought some bigger ones with red lights and wire connectors that I surface mounted. The new ones worked great but I had to use bigger amp connectors.

Ask for directions if you don't know how to install. The instillation went quickly on my Yahama cart and it was loud enough that I installed them right at the front blinker light under the fender.

Good product

1st off, they don't come with any installation instructions so you have to try and figure it out on your own. Tried searching on line for instructions but no bueno. The wires on the leads coming from the speakers are VERY small and it is almost impossible to crimp down the ends of the wire connectors. Once you crimp down the ends, the wires are so small that they pull out easily and you are left with useless connectors. Will be looking for a better product.