PSI Woodworking TCLVSKIT2 Variable Speed Lathe Conversion Kit

I didn't read the directions and I had it installed in under 30 minutes. I also installed a digital tachometer, and on the lowest pulley speed, I am getting a range of 480-1900RPM. I can't see needing to change the belt for speed adjustments at all.

It was easy to install and work great

It says this is compatible with the Rikon 70-105 so I figured it would fit the 700-100 since it is virtually identical except for the swing. You will need to drill the existing motor plate to fit this new motor, however, you will also need to purchase a smaller belt as the existing 70-100 belt is too big and you will not be able to swing the motor down far enough to put any tension on the belt. I gave up at this point even though I had it fully mounted in the unit when I discovered this but I am assuming you could find a smaller belt compatible with this. It is still cheaper to purchase this motor and find a new belt if you have the 70-100 and want the ease of a variable speed lathe but you may be better off choosing a small variable speed lathe to upgrade to and sell your 70-100 to offset the cost.

Had to deviate from the instructions a bit. Original Delta motor pully was too small for the new motor shaft so had to use the supplied pully instead. Also added a double pole switch to allow for reverse operation. Works great.

Just replaced the motor on my Delta midi lathe. It only took 20 minutes start to finish! Really good mounting plate too!