MUYI6 Pack Inline Fuse Holder - 14AWG Gauge Wire Pigtail Mini Blade Fuse Holder with 15A Mini Blade Fuses ATM

Good product, good price.

I like these. I bought two packs to run with wire harnesses for ATVs. I like the minis so these work well. So far I have run one with the supplied 5A fuse, and one with a 10A fuse due to the load. I haven't tested, but I doubt water will get in. They should not get submerged where I installed them, but the splashing should not affect them. Opening and closing was not a big deal, as some reviews said. My issue was how tight the fuses fit; putting the first one in was tough, to the point I bent the fuse a little. Take your time and work them in slowly. After that I was able to pull and install much easier. Will buy again.

Bought this for my '86 Honda TRX200SX project. The original fuse holder was completely busted, it was one of those bulky glass tube style fuses, at 15 amp rating. Bought this pack of two, comes with two fuse holders and two good quality 15 amp mini fuses. Wired it in place of the original fuse holder and everything works as expected. The holder is built well enough and closes tightly around the fuse to keep the elements out, the wires are firmly attached and sealed in place, a good tug would not pull these things apart. Everything is as expected for a great price, if you need a good deal for 15 amp fuses with holders for your automotive project these are the ones to get. Fuse holders have about half a foot of total wire, you cut the wire somewhere in the middle and install as needed. Perfect. Will update if any problems occur, do make sure you fully close the fuse holders once the fuse is installed to insure a good seal.

I like it! Crazy hard to install fuses though. I don't know what I'm doing wrong.

Easy install

These did the job I needed them to do. I cannot speak to the weather roof or waterproof properties of this item, because mine are mounted in my trunk, but the seal slips over the fuse nice and snug. The fuse is also held into the body of this very snug, so contact is great. Wire gauge is beefier than most, which is why I chose this one in particular. Doing well for me!

Very happy with this product, I used it on my bilge pump for my boat. Installation was easy and the perfect gauge wire.

I added this to a combination manual/automatic bildge pump on my boat. The pandemic shut down the marina so my boat lift isn't yet installed. I sleep easier knowing the pump is connected via a fuse rather than direct wired to the battery.