YaoFaFa Brake Bleeding 3L Brake Bleeder Kit,Manual Brake Fluid Pressure Bleeder with 1L Brake Fluid Extractor & 2PCS Cylinder Adapter Suitable for Most European Models and ABS Systems

It's very good should have bought one years ago well worth the money and top quality and doses the job

Easy to use got trapped air out of a brake system it’s now my go to brake bleeder the universal cap does leak if you can’t get it to seat correctly.

Got this as the air compressor vacuum one I got wasn’t performing well. This works so much better. Attach to reservoir, pump it up and away you go. Wish the actual bottle itself was smaller as you end up running out of fluid and sucking air bubbles in and not often you need litres and litres of brake fluid. But works well. Hose came with a cut in it so had to cut that out and shorten the hose but fine after that.

I had trouble bleeding my brakes so bought this never used one before.It was so easy to use and now my brakes are amazing now so thank you so much!

This product is not fit for purpose. It does not hold pressure which makes this a 2 person job. Had to resort to continuous pumping just to have 5psi of pressure!Do not purchase.

Ignore the electric ratchet in the picture.I have been meaning to get a pressurised bleeder for years but just never did until now and I really wish I got it earlier.This one came with a standard cap and a universal cap for different reservoirs, I had to use the universal one, which is a bit fiddly and you could do with an extra arm, but that's due to the vehicle reservoir design.I had a mishap and got brake fluid everywhere at first as I had not got the universal cap on properly and so when I pressurised it it just spat a load out the back and I panicked, but after that I just re adjusted the cap, slowly pressurised it and stayed for 10 seconds to make sure the pressure wasn't dropping before going to the caliper or clutch bleed nipple and had no issues after my first incident.It was amazing, if you are thinking about it, just get it bought

Be careful when using this. Even though the lid seemed to thread on perfectly I had a major leak when it was pressurised sending break fluid all over my engine. Two months later I had a coolant temperature sensor fail and when I took it out to replace it the connection was full of brake fluid. The universal adapter is not much better.

Very good quality