IPS 83687 2-Inch Flush Mechanical Cleanout Repair Plug

Good item

Fits perfectly

Had to lube the ring up to git it installed into my shop sink drain line, the plumbers didn't do as I asked and lower the clean out down to where the concrete surface would be, I showed how far up we were going to have it poured. (Down here in Tx, contractors Never Listen to who pays the bill!) Therefore, I cut the to high (Trip Hazard) - as close to flush as I could get with the slab (the clean outs were in a walk way area and also where I was going to store my large gas grill - Hence the Flush height requirement) - and the reason for this type of plug, (No Hub to screw a Brass Plug Into)! I had to cut both - the 4" & 2" Hubs Off! Pay $$ to "Professionals" and throw it away because of Arrogance! I do recommend this if you can't use a hub!

This device was recommended to me by a gentleman in the lava lamp sub-Reddit and an easy way to reseal my grande lava lamp after filtering. The device fits perfecting in the mouth of the globe. I did initially have a little trouble getting it to seal. I left it on top of the lamp for a little while it was cooling down and after a bit, it all came together. Perfect seal.The device comes with its own Allen wrench. You’ll need to keep that. Mine fell behind a shelf and went to Narnia, so I had order another which turned out to be longer and easier to use.I like this device and will be purchasing another for my next Grande lamp.

It is actually 2 1/8 inch and will not fit into a 2 inch id pipe

I needed this to seal a floor drain where there is lots of foot traffic. Mechanism works perfect for quick removal and installation when the need arises.

Same as another reviewer, I purchased this to seal a Grande Lava Lamp. Fit the cap like it was made for the purpose.

These are perfect for replacing worn out threads on sewer cleanouts.