Auxbeam 6 Gang Switch Panel BC60 Universal Circuit Control Relay System Automatic Dimmable LED Switch Pod Touch Control Panel Switch Box for Car Truck Pickup Boat UTV SUV - Blue, 3 Years Warranty

Excellent product for the price works well for light bar, rear bumper lights, rock lights, and have room for more hook up was simple and easy!!!

Great small switch controller for lights and ham radio. Small enough to mount easily and all power connections under the hood. Great setup and easy to wire and install.

Game changer for vehicles that are not equipped with factory upfitter switches. Easy install, Quality product with tons of labeling options.

Easy install, works as described on my Baja designs lights.

Why did you pick this product vs others?:UPDATE, the company reached out to me and offered to send me a panel without the low voltage shut off. If you are needing to use this to trigger a starter make sure you get the correct unit. I would buy from them again! The switch panel would be good if you are only wanting to run acc. I purchased this thinking I could use it as a 1 stop switch for my buggy. I was wanting to use to power fans, fuel pump, ignition, light. AND TO START THE BUGGY. It failed in my application. When you engage the starter the voltage draw drops below 12 volts ( normal operation) and when this occurs the switch panel turns off due to low voltage, thus causing everything to turn off. It's impossible to get around this. I did end up using it to power some LED light and some aux fans. It does good for that but in my opinion this switch is a FAIL

This is the new version with auto dimming/brightness. Previous versions had a white wire that you had to provide power to and pulse for changing the brightness. Glad they redesigned that. I wish it had a ‘light’ wire though so it’s not staying lit whole time car is on. It would be nice not to be backlit until vehicle lights were on. Guessing it was a design choice to keep limited wire runs. This version has a memory. If car is on and you have things active. You can press middle button and it turns everything off at once. Press again and it turns on everything that was on. When you turn car off and back on everything defaults to off. So if you have fans or coolers you need to remember to turn them back on. I have ran it for a couple of hours and it does not produce any heat. Very simple setup with very few wires or connections. I used the provided bracket (which is hidden under all of the foam) and hid the whole switching unit under some panels A few things I don’t like about this whole system. 1.The circuit breaker cover is too snug. If you push it all the way down it resets it, be sure to just set it on top but not push down all the way. Glad I tested it all out before putting cover on, otherwise that would have been confusing. 2. It’s not customizable. You get 2 each 5a, 10a, 20a and 30a fuses. What if you don’t need all those higher amperage ones. And you can’t move them around, you’re stuck using the switch in the order they set. 3. Short power wire from battery to circuit breaker 4. You can’t really add a fridge to it even though there’s a fridge label. Reason is, this panel only works with ACC so your car needs to be on. Not good for a fridge to always have your car running. I suppose you can have fridge wired in then when get to camp site move to other power source. 5. The power and ground cable ring are small. Will fit over 10mm bolt but not 12mm. I ended up widening the ring to fit on my battery terminal. 6. Not sure if it will support air compressor. My compressor has already an inline 20a fuse so my assumption is it will work but have not tried yet. 7. The brackets that come to mount the switch are good and bad. It has a couple of options / ways but it will most likely require altering your car. Overall though, nice alternative to the higher priced switching panels. it comes with high quality parts. Not all plastic. Easy to install. Looks good. Easy to use. If you have 2 or more accessories it’s worth it for a clean nice look with fewer wires and switches every where.

First of all, the packaging is very nice. Came with some brackets for the installation, only need to run 1 cable through the firewall, very easy to install, just hook up all your lights +/- wires into the panel, connect the panel to battery and ACC fuse (came with fuse tapper). One thing I noticed the auto dim still too bright for me, I just use a black marker cover the auto dim sensor, problem solved.

The days of running multiple wires through the firewall are over. Easy install & love the convenience of all lighting switches & junction box in one place. Ditch lights, bumper lightbar & roof lightbar on my tacoma all wired in.