3Pcs Decapping Pin

The ZOEKIM 3Pcs Decapping Pin set is a solid replacement for the Lee 90783/90292 Universal Decap Die. They fit properly, install easily, and function exactly as expected. I’ve been using them primarily for 9mm, and they decap smoothly without any issues.

They are a little thicker than the lee ones. Don't know if that is a bad thing maybe more sturdy.

The coating makes them a very tight fit into the tensioning nut. Good for use on normal reloads. Bend relatively easy if using on crimped primers or very dirty/aged range brass.

Worked and fit perfectly in my lee Universal. They actually were slightly tighter fitting than original.

After several years my Lee universal decapper pin broke. I used the original pin to prep thousands of cases, including swaged/sealed military ammo. While searching for a replacement I found these. As you can see in the pictures they're clearly not hardened. After 400+/- large rifle shells some swaged/sealed complete failure of the pins. Two are bent, one broke off, maybe low grade tool steel that's not hardened. They're also painted so resetting the height is required as they slip as the paint comes off. Zero stars, but it doesn't work.

Works very well. Absolutely no breaking of pins whatsoever when properly used. If you break a pin it is 100% that it wasn’t lined up correctly.

I put 25-30k rounds on the original pin before it bent. I bent all 3 of these in less than 4k. Might be good for an emergency spare but not for running a lot of rounds.

First, I'll say I was slightly disappointed that the tip got stuck in the first few cases testing these in a Frankford Arsenal hand deprimer. I then spun the pins in a drill against a piece of sandpaper using deprimed cases as a gauge to reduce the taper just enough until the cases didn't get stuck anymore. Now they work beautifully! I used to have trouble with Blazer brass not fully pushing the primers out and the anvil getting stuck on the pin. But now with these new pins every primer is being removed. I almost decided to stop processing Blazer brass because of the issue, but now my frustration is over. The stem measures .202 and they fit perfectly in the lee decapping die collet. So they must have addressed the issue I've read in a few other reviews. So even though I did have to rework the tips, I am giving these 5 stars for solving the Blazer brass issue.