Quadra-Fire Combustion Blower Motor for Mt. Vernon AE (SRV7000-588M)

A perfect fit!!! Just remember to place the 3 closer spaced holes to the top of the 6 holes in the fan base plate. And don’t forget to sandwich over a fresh gasket to prevent leaking of carbon monoxide gas or vacuum errors. If you forget this orientation none of the holes will line up with the screw treads. Also note that the screw treads are not fixed and may tend to slide away from the motor base plate while trying to seat them. I pulled my screws back out with a magnet and used the edge of a sharp knife to engage the treads against the metal base plate while screwing on the locking nuts. A Helpful hint is that a little drop of extra strength lock tight can be very helpful after drying to keep the screw threads from spinning loose or pushing backwards into the housing while trying to tighten the nuts over the fan base plate.

We have a Mt Vernon AE. fireplace insert. This meant the I had move the stove ~6-8 inches to reach around the back of the stove to remove the old blower pigtail and re-connect. If you are Handy and physically strong (to move the stove), not difficult at all. Much better than having to spray the original blower fan bearings with WD-40 every when the squeak from the running blower became unbearable.

Works well and fits great. On second ton of pellets it has become noisy like motor weight is not balanced. Does not affect performance but get son the nerves.

Plus - got the blower about 2 hours ago and it is in place and the stove is working great. Which is great since we had a cold snap last night.Con- it was missing a hole which I had to drill out as well as hog out all the holes to get it to fit (note that Mt Vernon AE stoves have screw studs in the blower body). The missing hole was just above the yellow tag in the photo. Not too big a deal but it added time to the task.I would give it a 5 star but the missing hole was wasted time.

Works well, as designed. It replaced an OEM combustion blower in a Quadrafire Mt. Vernon AE pellet stove. The flange is made to fit a few different models. But, they designed it to fit this stove as well. It's not a super easy job on an insert model, but doable without pulling the stove. It took 30 min or so to switch out.

Replaced the factory blower on our 10 year old pellet stove and this one fit the factory location perfectly.

had it in my gruby hands in three days, installed in 1/2 hour. replaced original 15year old blower that was a little noisy so probably didn't need it but this one is super quit.

Works great, however you have to be a contortionist to put it in the AE (Fireplace insert) It's placed on the right, but plugs in on the left. Difficult to line up the screw holes. But once it was in, it works very well. Packaged well.