Fortin EVO-ONE EVO-ONE All-in-One Remote Start, Security & Data Interface

This is now the fourth Fortin product I have installed. Unlike the EVO All, this installation took a little more time because there was no T-Harness and the remote start option was not available for the Acura TL with Push-to Start. There was a bit of splicing to be done and the12 gauge wires were soldered instead of spliced.The programming of the EVO ONE and RF antenna (via the Flashlink Updater) was painless. I recommend purchasing the Flashlink Updater. It allows you to customize your module if it's purchased without programming.Every small problem we encountered was resolved by Fortin's excellent tech support. I honestly believe it's top notch.We added the RFK942 RF kit to extend the range and when we were finished we had exactly what we were hoping for.Thank you Fortin!

Make your wife happy and get the Fortin remote start. This little gem is so easy to install with the Fortin T Harness. It really brings new life to a cold or hot car from the confines of your house. Save a marriage and get the Fortin Evo-One!

This install isn’t for beginners. Some reason there’s no T harness for Kia push-starts? You will need two diodes and wire for the hood switch before you install. And also the flash harness if you do not have one. Programming was easy. It works as expected so far. All I wanted it for was remote start in Arizona heat. Almost all companies want you to be a dealer to get install sheet and flashing software except Fortin. So it’s a plus! Instructions could be better.

I was told that factory fob could not be used with any remote starter for my Ram Promaster. Fortin's can and it works like a charm. Installation instructions were great, I took my time, programmed the unit and it works great. I may reprogram it again so I can use more of the alarm settings. The wiring instructions have clear pictures of the wires of the vehicle where everything is connected.I would buy it again in a minute

I work in electronics and figured this wouldn’t be too bad to install. Turns out you need to be a full blown electrical engineer and a wizard to hook this POS up. The guides they give you are difficult to read and wrong most of the time. You need to buy a $40 flash device to even use this device as well. I got it to work on my truck twice before it went to crap. Went through every possible solution before I donkey launched it into the dumpster where it belongs. Many hours and a few bucks wasted. DO NOT BUY.

Could not get the EVO-ALL to work with my 13 A5. This EVO-ONE worked perfectly. With the RF remotes and the factory key fobs as well. Fortin’s tech support it usually pretty good, but not not this time, I was taking a shot in the dark with this one and it worked!! Same AUD1-THAR.

This unit was extremely easy to install. I purchased the Fortin Flashlink 4 Bypass Module, to flash the key code and settings on the device, as well as the THOR-ONE-MAZ3 harness, since I installed this on a 2018 CX-9, which makes this plug and play and no need to splice into your vehicles existing harness. Of course be sure to get the correct harness for your application.

2013 Mazda CX-5 Automatic with Push StartInstallation takes about 2 hours (assuming you take your time)Check YouTube for helpful videos on installation. This works perfect and if you can DIY, you'll save at least $100 vs purchasing a preconfigured kit. I recommend using the Fortin THAR-ONE-MAZ3 wiring harness.Screenshots of my configuration are attached for reference.HIGHLY recommend.