Right Angle 6.35MM Adapter Golden Plated 90 Degree 3 Pole 6.35mm 1/4 Inch Stereo TRS Male Flat Pancake Style Plugs Connectors for Speaker,Patch Cable,Guitar(4 Pack/3 Pole)

Extremely low quality product.1) There is no insulator between the solder tabs and the outer casing.2) The solder tabs, rather than being at 90 degrees for easy access are almost aligned with each other making soldering of connections to both tabs more difficult. They are both pointed to the cable crimp area.3) The RING tab, (the longer tab) is so long that it is almost on top of that crimp area and the smallest pressure can push it down into contact with the casing quite easily, effectively grounding the RING to the SLEEVE4) All of the metal is quite thin compared to other plugs.5) The shafts of the plug on 4 out of 4 plugs was loose, rotated and one was so loose it wobbles.These are the worst plugs I've seen of this type and I have opened a few thousand TRS pancake plugs. Out of 4 plugs in the package not one was really usable. I grabbed the shaft on one with pliers just to inspect how it was spinning in the casing and the metal is so thin it just crushed it. I was not squeezing with a lot of force. I've used pliers on dozens if not hundreds of TRS pancake plugs before and never crushed one. For fun, I tested on another plug since I'd determined these were going in the garbage. It also easily crushed.Total garbage product. AVOID.I threw the whole package in the trash. They were unusable. I'd ask for a refund but its honestly just not worth my time.

These plugs make good contact all the way down the connector to the tip. I had bought a pair from somewhere else and the tip wouldn't make good contact to the solder connection. Causing intermiitent operation. These don't have that problem.

These are junk. One of the connectors "out of the bag" had a high resistance between the "ring" connections (300 Ohms), another in the pack the connector was "dented". The tabs are so close together I am sure shorting will be a problem unless after soldering you pot the connector with silicone or some other non-conductive material. I have purchased 1/4 inch stereo connectors from other on Amazon, much better quality. Buyer beware...

I like pancake connectors for my pedalboard, but this batch was difficult to solder and there were no built-in insulating barriers. I had to throw away several from the order because I ruined them during the soldering process, even though I am highly experienced at soldering 1/4" connectors.

These are the worst! The shaft is too long which prevents proper contact with ground and the jack protrudes 1/8". There is no interior insulator to prevent the tip from shorting to ground. The interior plating does not allow the ground shield to be soldered to the interior of the casing. Save yourself some time and buy Switchcraft. These are cheap but the quality is awful.

Even though I was meticulous in soldering the wires, I was getting intermittent connection to the tip.

Fell apart in my hands. Don’t buy.

The shaft is just a bit too long. Some jacks will allow this plug to bottom out on the body causing misalignment with the contacts.