Kenda Loadstar 8in. Bias-Ply Trailer Tire and Wheel Assembly with Integral Hub - 15 x 4.80 x 8, 1-Hole, Load Range A, Model Number HS408B-1I(A)

These are very nice. One problem I had was they pressed the bearings in to where the Valve stem faces towards my trailer instead of out. So to fill tire I have to reach around to the inside of the rim. Operator error.

bought this to replace the old wheel/tire on a garden cart with 1" axle shafts. Works well, although I had to change the original wheel retension method. Old wheel just used a cotter pin thru the shaft. Since the new wheel has separate bearings which must be retained, I had to drill and tap the end of the axle shaft for a screw and then use a shim washer stack on the axle to provide the appropriate amount of bearing freeplay.

It worked for my log splitter. Took 5 min to change the tires. Make sure to get the hub cap on good. So your bearings don’t dry out.

Exact replacement for my husked 35 ton log splitter. Just put a little more bearing grease on bearings that came with and installed. Took approx 10 minutes for entire process with normal hand tools.

The tire was the exact replacement for my 22 ton wood splitter and came ready to install.

This worked great on my wood splitter! Shipped fast and was exactly as described!

Replacement for mobile log splitter, matched up perfectly. 1 inch center

I love these tires I use them on my 4x8 1” single axle trailer I’ve no issues at all with them great product from these guys I highly recommend